Clip, Calling Line Identification - Motorola G24 Guide Developer's Manual

RING
AT+CRC=1//Enable extended ring format
OK
+CRING: REL ASYNC
+CRING: REL ASYNC
ath
AT+CRC=1
OK //Mobile fax call terminated (multi-numbered scheme) from PSTN fax machine
+CRING: ALT Voice/Fax
NO CARRIER
OK

+CLIP, Calling Line Identification

This command controls the Calling Line Identity (CLI) presentation indication to the terminal
when an incoming call is detected by the G24.
This command allows the user to query the provisioning status of the CLI by the network and by
the G24. The command also allows the user to enable/disable the CLI presentation by the G24 to
the terminal.
The +CLIP indication information varies depending on what is provided by the network and what
information is stored in the G24 phone book.
Command
Type
Set
Read
Test
+CLIP Indication
When the CLI presentation indication is enabled by the G24 (<n>=1), this unsolicited indication
is sent to the terminal after the RING indication.
+CLIP:<number>,<type>[,<subaddr>,<satype>[,[<alpha>][,<CLI validity>]]]
December 31, 2007
Syntax Response/Action
AT+CLIP=<n> OK
+CME ERROR: <err>
AT+CLIP? +CLIP: <n>, <m>
OK
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Remarks
The Set command enables or disables
the presentation of the CLI indication
from the G24 to the terminal.
Note: The Set command does not
address the network.
The Read command returns the +CLIP
enable/disable state in the G24 as well
as in the network provisioning state of
the CLI presentation.
The Test command returns the Set
command options (0,1).
3-21