Sony ZRD-1 Installation Manual page 95

How to clamp the cables
1. Bind the band of cable clamp around the cables, then pass it through the rectangular hole of cable
clamp.
t
Check that the jagged side of the cable clamp is set inside.
2. Secure the cables by pulling the band in the direction of the arrow.
t
After securing the cables with the cable clamp, cut the excess portion of the band as required.
Band of cable clamp
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
Display unit
Cables
Cable clamp
Rectangular hole
Cut the excess portion.
5-5 (E)