Sony ZRD-1 Installation Manual page 121

It is also possible to display the picture using one DVI connector. The setting example is as shown
below.
. Connector:
. Port:
. Picture allocation number: 1 to 18
Full HD
Port 1 to port 3
DVI 1 connector
Source equipment
[DisplayPort (Single1)]: Displays the picture using the DisplayPort 1 connector.
[DisplayPort (Single2)]: Displays the picture using the DisplayPort 2 connector.
[DisplayPort (Dual)]:
Also, the following information is displayed.
[Controller]
Controller with check mark: Primary controller
[Input]
The input channel that is set to the display controller is displayed.
[4K Quad Input]
Displays the 4K picture format (split type of input signal). The setting value is fixed by [HV Split].
HV Split
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
DVI 1 connector
Port 1 to port 3
Displays the 4K 120p picture using two DisplayPort connectors.
6-25 (E)