Sony ZRD-1 Installation Manual page 102

5. On the menu bar of the Main screen, click [Tool], and then click [Controller Settings].
The Controller Settings screen is displayed.
6. In [COM Port], select the COM port number to which the display controller is connected.
7. Click [Connect].
8. Change the IP address and subnet mask, and then type the default gateway.
Be sure to make a note of the IP address because it is needed in the procedure in Section 6-3-1.
9. Click [Apply].
10. Click (close).
The display returns to the Main screen before initial settings.
11. Disconnect the power cord and USB cable, and connect them to the next display controller.
12. Repeat steps 5 to 11.
13. After changing the IP address of all display controllers, perform the Controller Connection setting.
(Refer to Section 6-3-1.)
6-6 (E)
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200