Sony ZRD-1 Installation Manual page 109

8. Confirm the settings.
[OK]: The settings are registered in the display controller. The settings are saved in the Display
Control Software. If the connection or setting to the display controller has failed, an error
message is displayed. Follow the instructions on the message. The display returns to the
Main screen after initial settings.
[Apply]: The settings are registered in the display controller. The settings are saved in the Display
Control Software. If the connection or setting to the display controller has failed, an error
message is displayed. Follow the instructions on the message.
[Cancel]: The display returns to the Main screen before initial settings without saving the settings.
9. Turn on the power to system. (Refer to Section 6-4.)
In the case of the system using two or more display controllers, turn on the power, then reset the
display controller settings. (Refer to Section 6-10.)
n
Be sure reset the settings after turning on the power to system.
Connection pattern
About the indication in the illustration
O : Starting point. This indicates the point where the signal is input first.
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
6-13 (E)