Sony ZRD-1 Installation Manual page 124

3. Select the mode number to be set in [Picture Mode]. (Version 1.20.0 or later)
4. Adjust the picture quality. When the settings are changed, they are reflected immediately.
[Contrast]
Change the setting using the sliding lever and
value also changes.
[Default]: 60
[Brightness]
Change the setting using the sliding lever and
value also changes.
[Default]: 50
[Gamma]
Select the gamma correction.
[Default]: 2.2
n
. This product is not a medical device. The device cannot be used for medical examinations, even
when [DICOM SIM] is selected.
. When the setting of [HDR] is other than "Off", the [Gamma] setting is disabled. (Version 1.20.0 or
later)
. For details on [custom5] to [custom10], refer to the Protocol Manual. (Version 1.20.0 or later)
t
[DICOM SIM] can be selected in the following devices.
. SY model: S/N 2000101 and later
. CN model: All S/Ns
. ZRCT-200
[HDR] (ZRCT-200 only)
[SMPTE ST 2084] (Version 1.20.0 or later):
Displays the HDR (High Dynamic Range) picture of SMPTE ST 2084 standard. This takes
precedence over the value set in [Gamma].
[S-Log3] (Version 1.20.0 or later):
Displays the HDR picture of S-Log3. This takes precedence over the value set in [Gamma].
[ITU-R BT.2100 (HLG)] (Version 1.22.0 or later):
Displays the HLG (Hybrid Log Gamma) picture of ITU-R Recommendation BT.2100-defined.
This takes precedence over the value set in [Gamma].
[S-Log3 (Live)] (Version 1.22.0 or later):
Displays the HDR picture in which the system gamma is added to the S-Log3 input signal. This
takes precedence over the value set in [Gamma].
[Off]
About [S-Log3]
[S-Log3] is the setting for which this unit is used as the reference monitor in the S-Log3 Live HDR
workflow which Sony advocates. Displays the S-Log3 input signal adding the system gamma.
This system gamma is set so that the compatibility with the monitoring of the conventional (SDR) environment is
valued and you can perform suitable picture expression without discomfort when adjusting the picture of the HDR
camera.
6-28 (E)
(0 to 100). When you move the sliding lever, the
(0 to 100). When you move the sliding lever, the
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200