Sony ZRD-1 Installation Manual page 118

[Light Output] (Version earlier than 1.20.0 only)
Changes the output when you want to operate the system with low light source output.
[Full(Default)]: 100%
[High]: 75%
[Medium]: 50%
[Low]: 25%
t
In the version 1.20.0 or later, the item [Light Output] is displayed on the Picture Settings screen.
[Test Pattern]
Select the test pattern and click [ON]. When you click [OFF], the display returns to normal state.
[Photo Mode] (Reserved)
This item is reserved for future function.
[POWER] block
. [Direct Array Power On]
Selects whether or not to turn on the power of display controller and display units linked with the tim-
ing when the power cord is connected to the AC inlet of display controller.
[ON]: When the power cord is connected only to the display controller, both display controller and
display units are powered on. Be sure to connect the power cord of display units to the circuit
breaker.
[OFF]: When the power cord is connected to the display controller, the display controller enters
standby state. The power of display units is not turned on.
. [Display Unit Power On Delay]
Sets the time lag of turning on the power of display unit. Enter the value in the range of 0 to 65535 (unit:
ms). The startup time increases as the number of display units increases. Therefore, be sure to deter-
mine the time lag setting taking into consideration the number of display units.
4. Click [Close].
The System Settings screen is closed.
6-22 (E)
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200