Sony ZRD-1 Installation Manual page 79

4. Insert the hexagon wrench into one of the two shafts. Turn the hexagon wrench counterclockwise to
loosen the shaft lock fully.
n
Loosen the lock fully. If not, you may not be able to adjust in the Z direction in step 5.
In the far-left display unit viewed
from the rear, loosen the shaft
on the right side.
5. Insert the ball-pointed hexagon wrench into the adjustment screw. Turn the ball-pointed hexagon
wrench (to the B direction) to fine adjust the display unit in the Z direction by visually checking the
array from the front side.
6. Tighten the lock loosened in step 4.
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
Rear of the array
In the other display units,
loosen one of the two shafts.
Adjustment screw
Joint position to be
fine adjusted
B
Ball-pointed hexagon wrench
Hexagon wrench
In the far-right display unit viewed
from the rear, loosen the shaft
on the left side.
Z
Shaft
2-45 (E)