Syslog; Set Log Notification Destination (Syslog Server); Set Log Output Level (Debug) - Yamaha L2 Command Reference Manual

46 | Command Reference | Maintenance and operation functions
[Initial value]
management interface vlan1
[Input mode]
global configuration mode
[Description]
Set the VLAN that is used for management.
By setting this command, it will be possible to set and acquire the IP address assigned by the L2MS master to the corresponding
VLAN when operating as an L2MS slave.
If this is executed with the "no" syntax, or if the VLAN is deleted, this command also returns to the default settings.
[Example]
Set VLAN #2 as the management VLAN.
SWR2311P(config)#management interface vlan2

4.9 SYSLOG

4.9.1 Set log notification destination (SYSLOG server)

[Syntax]
logging host host
no logging host
[Parameter]
host
[Initial value]
no logging host
[Input mode]
global configuration mode
[Description]
Specifies the IP address of the SYSLOG server to which log notifications are sent.
Up to 2 entries can be specified.
If this command is executed with the "no" syntax, the setting returns to its default value, and notifications are not sent.
[Example]
Set the SYSLOG server IPv4 address to 192.168.100.1.
SWR2311P(config)#logging host 192.168.100.1
Set the SYSLOG server IPv6 address to fe80::2a0:deff:fe11:2233.
SWR2311P(config)#logging host fe80::2a0:deff:fe11:2233%vlan1

4.9.2 Set log output level (debug)

[Syntax]
logging trap debug
no logging trap debug
[Initial value]
no logging trap debug
: A.B.C.D
IPv4 address of the SYSLOG server
: X:X::X:X
IPv6 address of the SYSLOG server
If you specify an IPv6 link local address, you must also specify the output interface (fe80::X%vlanN
format)