Show Status Of Qos Function Setting; Show Qos Information For Lan/Sfp Port - Yamaha L2 Command Reference Manual

SWR2311P(config-if)#qos trust dscp
Set the trust mode of the LAN/SFP port to the default setting (CoS).
SWR2311P(config-if)#no qos trust
or
SWR2311P(config-if)#qos trust cos

9.2.4 Show status of QoS function setting

[Syntax]
show qos
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the enabled (Enable) or disabled (Disable) status of the QoS function.
[Example]
Show the status of the system's QoS setting.
SWR2311P#show qos
Enable

9.2.5 Show QoS information for LAN/SFP port

[Syntax]
show qos interface [ifname]
[Parameter]
ifname
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows QoS settings for the specified LAN/SFP port. The following content is shown.
Item
Port Trust Mode
Input Policy-Map Name
Port Default CoS Priority
Port-Priority-Queue
Egress Traffic Shaping
Egress Traffic Queue Shaping
Queue Scheduling
CoS (Queue)
DSCP (Queue)
Special Queue Assignment: Sent From CPU
Note 1) Not shown if no policy map is applied. For details on class map information, refer to the show class-map command.
Note 2) Shown only for CoS trust mode.
Note 3) Shown only if the trust mode is "port priority."
Note 4) Shown only for DSCP trust mode.
: Name of the LAN/SFP port. If this is omitted, the command applies to all ports.
Interface to show
Command Reference | Traffic control | 229
Description
Trust mode of LAN/SFP port (CoS/DSCP/Port-Priority)
Name of policy map already applied to the LAN/SFP port
class map information (note 1)
Default CoS value (note 2)
Port priority order (note 3)
Traffic shaping (individual port)
Traffic shaping (individual queue)
Egress queue scheduling format and weight
CoS - egress queue ID conversion table (note 2)
DSCP - egress queue ID conversion table (note 4)
Specify the egress queue of the frames transmitted from the
CPU