Chapter 3: Configuration; Manage Setting Values; Default Setting Values - Yamaha L2 Command Reference Manual

Chapter
3
Configuration

3.1 Manage setting values

The SWR2311P uses the following configurations to manage its settings.
Types of configuration
Running configuration (running-config)
Startup configuration (startup-config)
Default configuration (default-config)
The start-up flow for the SWR2311P system is as follows.
1. The setting value of the startup-config select command is referenced to determine the startup config that will be used.
If sd is selected by the startup-config select command, and an SD card is not inserted, startup config #0 is selected.
2. If the startup configuration that was selected exists, the data in question is deployed to RAM as a running configuration.
If the startup configuration file that was selected according to the setting values in the startup-config select command does
not exist in ROM, the default configuration is deployed to RAM.
If commands etc. are used to modify the settings while the SWR2311P is running, the modified settings are immediately
reflected in the running configuration. After modifying the running configuration, executing the write or copy command will
update the startup configuration. If you restart without saving the content that was specified or modified, the settings or
modifications are lost. Please be aware of this.

3.2 Default setting values

The default setting values for the SWR2311P are shown in the table below.
• Default setting values for the entire system
Category
Terminal settings
Password
Time management
RMON
Firmware update
Description
Setting values currently used for
operation. Managed in RAM.
These are the saved setting values. This
manages 5 configurations in ROM and 1
configuration on an SD card. The data in
ROM to be used is determined using the
startup-config select command.
The single configuration on the SD card
is managed in the "\swr2311p\startup-
config" folder.
Default setting values. Managed in
ROM.
Setting item
Console timeout
Number of VTYs
Number of lines displayed
Login password of no user
Administrator password
Password encryption
Time zone
NTP server
NTP update cycle
Behavior
Download URL
Command Reference | Configuration | 23
User operations that can be
performed
Note / Save to startup configuration
Note / Delete / Copy
No operations possible
Default value
600 sec
8
24
none
none
not encrypted
JST (UTC + 9.0H)
none
once per hour
enabled
firmware-update url http://
www.rtpro.yamaha.co.jp/firmware/
revision-up/swr2311p.bin