Set Default Led Mode; Show Led Mode - Yamaha L2 Command Reference Manual

108 | Command Reference | Maintenance and operation functions
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Unmounts the SD card.
If this command is not executed, or if the SD card is removed from the SD card slot without executing the unmount process
from the web GUI, there are some cases in which the operating system will generate a warning to repair the card's file system.
[Note]
The SD card cannot be used if the SD card is in an unmounted state.
[Example]
Unmount the SD card.
SWR2311P>unmount sd

4.23.6 Set default LED mode

[Syntax]
led-mode default mode
no led-mode default
[Parameter]
mode
[Initial value]
led-mode default link-act
[Input mode]
global configuration mode
[Description]
Set the default LED mode.
When you execute this command, the LEDs are lit in the specified mode. The LEDs are lit in the specified mode even when a
loop is detected in STATUS mode and the loop status has been resolved.
If this command is executed with the "no" syntax, the setting returns to the default.
[Example]
Set the default LED mode to OFF mode.
SWR2311P(config)#led-mode default off

4.23.7 Show LED mode

[Syntax]
show led-mode
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the LED mode setting and status.
The following items are shown.
• Default LED mode setting
• Current LED mode status
: Default LED mode
Setting value
link-act
poe
vlan
status
off
Description
LINK/ACT mode
PoE mode
VLAN mode
STATUS mode
OFF mode