Set Traffic-Shaping (Queue Units) - Yamaha L2 Command Reference Manual

[Initial value]
no traffic-shape rate
[Input mode]
interface mode
[Description]
Specifies shaping for the port.
If this is executed with the "no" syntax, the port shaping setting is disabled.
[Note]
In order to execute this command, QoS must be enabled.
Since rounding occurs on the traffic rate, the value actually applied to the input value might be less.
Input value
18 - 23476
23477 - 1000000
[Example]
Reduce transmission from LAN port #1 down to CIR:30016 kbps, Bc:1876000 byte.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#traffic-shape rate kbps 30016 burst 1876

9.2.43 Set traffic-shaping (queue units)

[Syntax]
traffic-shape queue queue-id rate kbps CIR burst BC
no traffic-shape queue queue-id rate
[Parameter]
queue-id
CIR
BC
[Initial value]
no traffic-shpe queue 0 rate
no traffic-shpe queue 1 rate
no traffic-shpe queue 2 rate
no traffic-shpe queue 3 rate
no traffic-shpe queue 4 rate
no traffic-shpe queue 5 rate
no traffic-shpe queue 6 rate
no traffic-shpe queue 7 rate
[Input mode]
interface mode
[Description]
Specifies shaping for the egress queue of the port.
If this is executed with the "no" syntax, the egress queue shaping setting is disabled.
[Note]
In order to execute this command, QoS must be enabled.
Since rounding occurs on the traffic rate, the value actually applied to the input value might be less.
: <0-7>
Egress queue ID
: <18-1000000>
Traffic rate (kbps). Since rounding occurs, the value actually applied to the input value might be less
(see [Note])
: <4-16000>
Burst size (kbyte). Specified in 4-kbyte units.
Command Reference | Traffic control | 257
Traffic rate granularity (kbps)
17.28
261