Set Firmware Update Reload Time; General Maintenance And Operation Functions; Set Host Name - Yamaha L2 Command Reference Manual

106 | Command Reference | Maintenance and operation functions
New Revision:
Update to this firmware? (Y/N)y
Continue without unmounting the SD card? (Y/N)n
Unmounted the SD card.
Updating...
Finish
SWR2311P#

4.22.7 Set firmware update reload time

[Syntax]
firmware-update reload-time hour [min]
no firmware-update reload-time
[Parameter]
hour
min
[Input mode]
global configuration mode
[Description]
Sets the time at which the new firmware is applied by restarting after a firmware update.
If this command is executed with the "no" syntax, the new firmware is applied by restarting immediately after the firmware is
updated.
[Example]
Specify AM 1:30 as the restart time for updating the firmware.
SWR2311P(config)#firmware-update reload-time 1 30
SWR2311P(config)#

4.23 General maintenance and operation functions

4.23.1 Set host name

[Syntax]
hostname hostname
no hostname [hostname]
[Parameter]
hostname
[Initial value]
hostname SWR2311P
[Input mode]
global configuration mode
[Description]
Specifies the host name.
The host name specified by this command is used as the command prompt. If SNMP access is possible, this is used as the value
of the MIB variable sysName.
If this command is executed with the "no" syntax, the setting returns to the default value.
[Example]
Set the host name as "yamaha."
SWR2311P(config)#hostname yamaha
yamaha(config)#
Rev.2.02.03
Pull out the SD card.
: <0-23>
Firmware update reload time (hour)
: <0-59>
Firmware update reload time (minutes)
: Single-byte alphanumeric characters and single-byte symbols (63characters or less)
Host name