Yamaha L2 Command Reference Manual page 118

118 | Command Reference | Interface control
Ingress filter
Acceptable frame types
Default Vlan
Configured Vlans
input
output
*1 Shown only for physical interface
*2 Shown only for physical interface and logical interface
*3 Shown only for VLAN interface
*4 In the case of logical interface and VLAN interface, shows the minimum value for the physical interface belonging to that
interface
*5 Shows the transmission information when tail dropping is enabled, and the information only for reception when tail dropping
is disabled.
[Example]
Show the status of LAN port #1.
SWR2311P# show interface port 1.1
Interface port1.1
Link is UP
Hardware is Ethernet
HW addr: 00a0.de00.0000
Description: Connected to router
ifIndex 5001, MRU 1522
Speed-Duplex: auto(configured), 1000-full(current)
Auto MDI/MDIX: on
Vlan info:
Switchport mode
Ingress filter
Item
packets
bytes
multicast packets
drop packets
packets
bytes
multicast packets
broadcast packets
drop packets
: access
: enable
Description
• trunk : tagged
Status of ingress filtering
• enable : enabled
• disable : disabled
Frame types that can be received
• all : All frames are received
(regardless of whether they are
tagged or untagged)
• vlan-tagged only : Only frames with
a VLAN tag are received
VLAN ID that handles untagged frames
• For an untagged port: VLAN
specified by the switchport access
vlan command
• For a tagged port: Native VLAN
• For a tagged port and set to receive
only tagged packets: None
• If unspecified: vlan1
List of the VLAN IDs that belong to the
corresponding interface
Number of received packets *2
Number of received bytes *2
Number of received multicast packets *2
Number of overflowed packets received
*2, *5
Number of transmitted packets *2
Number of transmitted bytes *2
Number of transmitted multicast packets
*2
Number of transmitted broadcast
packets *2
Number of tail-dropped packets
transmitted *2, *5