Siemens SINUMERIK 828D Operating Manual page 829

Parameter
F1
X1
Z1
Y1
β2
γ2
Tracking
F3
X3
Z3
Tool change
T
D
F4
X4
Z4
β5
γ5
Tracking
F6
X6
Z6
Y6
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Feedrate to approach the first position
Alternatively, rapid traverse
1. position (inc or ∅ abs)
1. position (inc or ∅ abs)
Retraction to safety clearance
Beta angle for 1st swivel movement
Gamma angle for 1st swivel movement
The position of the tool tip is maintained during swiveling.
Please refer to the machine manufacturer's instructions.
Feedrate to approach the third position
Alternatively, rapid traverse
3. position (inc or ∅ abs)
3. position (inc or ∅ abs)
TlChngPt: Approach the tool change point from the last programmed position
•
and carry out a tool change
Direct: Tool is not changed at the tool change position, but at the last pro-
•
grammed position
No: Tool is not changed
•
Tool name (not for tool change "no")
Cutting edge number (not for tool change "no")
Feedrate for approach to the fourth position
Alternatively, rapid traverse
4. position (inc or ∅ abs)
4. position (inc or ∅ abs)
Beta angle for 2nd swivel movement
Gamma angle for 2nd swivel movement
The position of the tool tip is maintained during swiveling.
Please refer to the machine manufacturer's instructions.
Feedrate to approach the sixth position
Alternatively, rapid traverse
6. position (inc or ∅ abs)
6. position (inc or ∅ abs)
Retraction to safety clearance
Working with a B axis (only 840D sl)
16.5 Approach/retraction
Unit
mm/min
mm
mm
mm
Degrees
Degrees
mm/min
mm
mm
mm/min
mm
mm
Degrees
Degrees
mm/min
mm
mm
mm
829