Siemens SINUMERIK 828D Operating Manual page 302

Programming technology functions (cycles)
9.1 Drilling
Parameters, G code program
PL Machining plane
RP Retraction plane
SC Safety clearance
F Feedrate
Parameter Description
Machining posi-
Single position
•
tion (only for G
Drill hole at programmed position
code)
Position pattern
•
Position with MCALL
Z0 (only for G Reference point Z
code)
FR (only for G Feedrate during retraction
code)
FR (only for Feedrate during retraction
ShopTurn)
Machining
Face C
•
surface
Face Y
•
(only for Shop-
Peripheral surface C
•
Turn)
Peripheral surface Y
•
Position
At the front (face)
•
(only for Shop-
At the rear (face)
•
Turn)
Outside (peripheral surface)
•
Inside (peripheral surface)
•
Clamp/release spindle
The function must be set up by the machine manufacturer.
(only for Shop-
Turn)
Z1 Drilling depth (abs) or drilling depth in relation to Z0 (inc)
It is inserted into the workpiece until it reaches Z1.
DT
Dwell time (at final drilling depth) in seconds
•
Dwell time (at final drilling depth) in revolutions
•
* Unit of feedrate as programmed before the cycle call
302
Parameters, ShopTurn program
T
mm D
mm F
* S / V
Tool name
Cutting edge number
Feedrate
Spindle speed or constant cut-
ting rate
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
mm/min
mm/rev
rpm
m/min
Unit
mm
*
mm/min
mm/rev
mm
s
rev
Turning