Siemens SINUMERIK 828D Operating Manual page 479

Parameter
FS
ZFS
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
Milling direction
RP Retraction plane
F Feedrate
Parameter
Machining
surface
Position
(only for ShopTurn)
(only for ShopTurn)
Machining
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Chamfer width for chamfering - (for chamfering only)
Insertion depth of tool tip (abs or inc) - (for chamfering only)
simple
•
mm
*
Description
Face C
•
Face Y
•
Peripheral surface C
•
Peripheral surface Y
•
At the front (face)
•
At the rear (face)
•
Outside (peripheral surface)
•
Inside (peripheral surface)
•
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
The following machining operations can be selected:
∇ (roughing)
•
∇∇∇ (finishing)
•
∇∇∇ edge (edge finishing)
•
Chamfering
•
Programming technology functions (cycles)
ShopTurn program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
9.4 Milling
Unit
mm
mm
mm/min
mm/rev
rpm
m/min
479