Parameters
S
α1
Z1
ZR
FR
Fixed
stop
Parameters
Function, withdrawing
Withdraw blank
Also take zero point
Work offset
- for take zero point
"yes"
Z1
F
Parameters
Machining side function
Spindle selection
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Spindle speed – (only when the spindles rotate)
Angular offset
Transfer position (abs.)
Position, feedrate reduction (abs or inc)
Position from which a reduced feedrate is used.
Reduced feedrate
Travel to fixed stop
Yes
•
The counter-spindle stops at a defined distance away from transfer position
Z1 and then traverses with a defined feedrate up to the fixed stop.
No
•
The counter-spindle traverses to the transfer position Z1.
Description
From main spindle
•
From counter-spindle
•
Also take zero point
Yes
•
No
•
Work offset in which the coordinate system offset by Z1 must be saved.
Basic reference
•
G54
•
G55
•
G56
•
G57
•
...
•
Amount by which the workpiece is withdrawn from the main spindle (inc)
Feedrate
Description
Main spindle
•
Machining along the main spindle
Counter-spindle
•
Machining along the counter-spindle
Multi-channel machining
10.2 Multi-channel support
Unit
rev/min
Degrees
mm/rev
Unit
mm/min
Unit
663