Tool List - Siemens SINUMERIK 828D Operating Manual

12.5

Tool list

All parameters and functions that are required to create and set up the tools are displayed in
the tool list.
Each tool is uniquely identified by the tool identifier and the replacement tool number.
For the tool display, i.e. when displaying the cutting edge positions, the machine coordinate
system is taken into account.
Tool parameters
Column heading
Location
BS
*
* If activated in magazine
selection
Type
Tool name
ST
D
Length X, length Z
Radius
∅
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Meaning
Magazine/location number
•
•
The following icons can also be displayed for other magazine types (e.g.
for a chain):
•
*
•
Tool type
Specific tool offset data is displayed depending on the tool type (repre-
sented as an icon).
The icon identifies the position of the tool; this was selected when the tool
was created.
You have the option of changing the tool position or the tool type using
the <SELECT> key.
The tool is identified by the name and the replacement tool number. You
can enter the name as text or number.
Note: The maximum length of tool names is 31 ASCII characters. The
number of characters is reduced for Asian characters or Unicode charac-
ters. The following special characters are not permitted: | # ".
Replacement tool number (for replacement tool strategy).
Cutting edge number
Tool length
Geometry data length X and length Z
Tool radius
Tool diameter
The magazine location numbers
The magazine number is specified first, followed by the location num-
ber in the magazine.
If there is only one magazine, only the location number is displayed.
Load position in the load magazine
Spindle location as an icon
Locations for gripper 1 and gripper 2 (applies only when a spindle with
dual gripper is used) as icons.
Tool management
12.5 Tool list
679