The tool creation sequence can be defined differently.
Unloading a tool in a file
According to the corresponding setting, after being read out, the unloaded tool is deleted
from the NC memory.
Deleting a tool in a file
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
6.
Press the "OK" softkey.
The tool is added to the tool list with the specified name. If the cursor is
located on an empty magazine location in the tool list, then the tool is
loaded to this magazine location.
1.
The tool list is opened.
2.
Place the cursor on the tool that you would like to unload from the mag-
azine and press the "Unload" and "In file" softkeys.
3.
Navigate to the required directory and press the "OK" softkey.
4.
Enter the required file name in the "Name" field and press the "OK"
softkey.
The field is pre-assigned with the tool names.
The tool is unloaded and the data of the tool are written to the file.
1.
The tool list is opened.
2.
Position the cursor on the tool that you wish to delete.
3.
Press the "Delete tool" and "In file" softkeys.
3.
Navigate to the required directory and press the "OK" softkey.
4.
Enter the required file name in the "Name" field and press the "OK"
softkey.
The field is pre-assigned with the tool names.
The tool is unloaded and the data of the tool are written to the file. The
tool is then deleted from the NC memory.
Tool management
12.5 Tool list
695