Siemens SINUMERIK 828D Operating Manual page 471

Parameter Description
FS Chamfer width for chamfering - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering only)
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
Milling direction
RP Retraction plane
F Feedrate
Parameter Description
Machining
•
surface
•
Position
•
(only for ShopTurn)
•
Clamp/release spindle (only for face C)
The function must be set up by the machine manufacturer.
(only for ShopTurn)
Machining The following machining operations can be selected:
•
•
•
•
The positions refer to the reference point:
X0 (only G code) Reference point X
Y0 (only G code) Reference point Y
Z0 Reference point Z
∅ Diameter of blank spigot
N Number of edges
SW or L Width across flats or edge length
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
simple
•
mm
*
Face C
Face Y
Front
Back
∇ (roughing)
∇∇∇ (finishing)
∇∇∇ edge (edge finishing)
Chamfering
Programming technology functions (cycles)
ShopTurn program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
9.4 Milling
Unit
mm
mm
%
mm/min
mm/rev
rpm
m/min
mm
mm
mm
mm
mm
471