Siemens SINUMERIK 828D Operating Manual page 329

Parameters in the mode "Input simple" (only for G code program)
G code program parameters
Input
RP Retraction plane
Parameter Description
Compensating
•
chuck mode
•
Machining
•
position
•
Z0 Reference point Z
Z1 End point of the thread (abs) or thread length (inc)
It is inserted into the workpiece until it reaches Z1.
Machining - (with
•
compensating
chuck)
•
- Define "Pitch" parameter
Pitch - (only ma-
•
chining without
encoder)
•
Thread Direction of rotation of the thread
•
•
(only in mode "without compensating chuck")
P Pitch ...
•
•
•
•
The pitch is determined by the tool being used
S Spindle speed - (only for tapping without compensating chuck)
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
simple
•
mm
with compensating chuck
Without compensating chuck
Single position
Drill hole at programmed position.
Position pattern
Position with MCALL
With encoder
Tapping with spindle encoder
without encoder
Tapping without spindle encoder; selection:
User input
Pitch is obtained from the input
Active feedrate
Pitch is obtained from the feedrate
Right-hand thread
Left-hand thread
in MODULUS: MODULUS = Pitch/π
in turns per inch: Used with pipe threads, for example.
When entered per inch, enter the integer number in front of the decimal point in the
first parameter field and the figures after the decimal point as a fraction in the sec-
ond and third field.
in mm/rev
in inch/rev
Programming technology functions (cycles)
9.1 Drilling
mm
mm
MODULUS
Turns/"
mm/rev
in/rev
329