Siemens SINUMERIK 828D Operating Manual page 311

Parameter Description
Position (only for
•
ShopTurn)
•
•
•
Clamp/release spindle
The function must be set up by the machine manufacturer.
Z1 Drilling depth (abs) or drilling depth in relation to Z0 (inc)
It is inserted into the workpiece until it reaches Z1.
D - (only for G 1. Drilling depth (abs) or 1st drilling depth in relation to Z0 (inc)
code)
D - (only for Shop- Maximum depth infeed
Turn)
Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter Description
PL (only for G Machining plane
code)
SC (only for G Safety clearance
code)
Drilling depth Drilling depth in relation to the tip
FD1 Percentage for the feedrate for the first infeed
DF Percentage for each additional infeed (for swarf removal
only)
V1 Minimum infeed
V2 Retraction distance after each machining step
Clearance distance The clearance distance is calculated by the cycle
DBT (only for G Dwell time at drilling depth
code)
DT Dwell time at final drilling depth
DTS (only for G Dwell time for swarf removal (for swarf removal only)
code)
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
At the front (face)
At the rear (face)
Outside (peripheral surface)
Inside (peripheral surface)
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Programming technology functions (cycles)
Value Can be set in SD
Defined in MD
52005
1 mm
Tip
90 %
90 %
1.2 mm
1.4 mm
Automatic
0.6 s
0.6 s
0.6 s
9.1 Drilling
mm
mm
x
x
x
x
x
x
x
x
311