Note
Selected section
The selected sections and size changes are kept as long as the program is selected.
6.9.2
Panning a graphical representation
Precondition
The simulation or the simultaneous recording is started.
Procedure
6.9.3
Rotating the graphical representation
In the 3D view you can rotate the position of the workpiece to view it from all sides.
Requirement
Simulation has been started and the 3D view is selected.
Procedure
...
...
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
1.
Press a cursor key if you wish to move the graphic up, down, left, or
right.
1.
Press the "Details" softkey.
2.
Press the "Rotate view" softkey.
3.
Press the "Arrow right", "Arrow left", "Arrow up", "Arrow down", "Arrow
clockwise" and "Arrow counterclockwise" softkeys to change the posi-
tion of the workpiece.
- OR -
6.9 Editing and adapting a simulation graphic
Simulating machining
211