Sony 158SVR2000 Setup Manual page 54

Note
• In this method, when you find the correct
code, it will automatically program the
TV POWER, VOL
+/-,
and MUTING
buttons on the Remote Control.
• If you have a stereo system connected to
the SVR Recorder, you can program the
POWER button on the Remote Control to
turn on and off both the stereo and your
TV. To do so, use code 1999 Instead of
0999 In step 1.
• To reset the Remote Control back to the
manufacturer's settings, press and hold
the TiVo and TV POWER buttons together
for three seconds until the LED on the
Remote Control remains lit. Enter code
0981 (or 1981) usmg the number keys on
the Remote Control.
541
Programming Your Remote Control
Code Search Method
Another method of programmmg the Remote Control to operate your TV and/or stereo
system IS the code search method. The Remote Control has hundreds of available
codes. The correct code for your TV mIght be available, yet not listed on the screen for
your TV brand.
1
Put the Remote Control in code search mode.
a) Press the TiVo button and TV POWER sImultaneously for three seconds until
the LED on the Remote Control remams lit contmuously.
b) Release the buttons and the LED remams illummated.
c) Usmg the number keys on the Remote Control, enter the code 0999
2
Test the code.
a) Pomt the Remote Control at the TV, press TV POWER and see If the TV turns
off or on.
b) If the TV does tum off or on, confirm that MUTE and VOL (volume) +/- also
operate the TV If they do, go to step 4 below. If they do not, contmue WIth
step 3.
3
Try another code.
Contmue to cycle through each code by pressmg CH+, then test the code by
repeatmg step 2 above. Remember, there are hundreds of codes. If the LED goes
out. you have reached the end of the codes.
4
Program the Remote Control with the correct code.
a) When the code allows the Remote Control to operate the TV power, volume and
mutmg, press ENTER to set the code and eXIt Code Search mode.
b) You can also press CLEAR to eXIt Code Search mode WIthout settmg a new
code.