Sony 158SVR2000 Setup Manual page 32

Note
Your VCR
IS
probably already hooked up to
your TV. So, once you've connected the 5VR
Recorder to your VCR, you've also Indirectly
hooked up the 5VR Recorder to your TV. The
5VR Recorder will send Its signal to your
VCR, and
In
turn your VCR will send the 5VR
Recorder's signal to your TV.
IR Output to Sony VCR
.".... To cable/satellite box if needed
SVR
Recorder
Sony
VCR
TV
321
Continuing Your Connection Steps
Continuing Your Connection Steps
Once you've completed steps 1 and 2 for your particular connection, contmue here
with step 3.
3
Connect the SVR Recorder to your TV and/or VCR.
If you don't have a VCR, skip to step 3c.
3a Video Output to VCR and TV.
First, look at the back of your VCR and see what types of Jacks are available.
Choose the best you have from the followmg optIOns, and connect the SVR
Recorder output to your VCR mput.
• S-Video cable, along with the LeftIRlght (white and red) Audio cable (best)
• Composite Video (yellow) and LeftIRlght Audio (white and red) (better)
• RF Out, usmg the RF CoaXial cable (good)
Next, connect your VCR output to your TV mput, agam usmg the best
connection available (see Note).
If you are connectmg usmg RF Coaxial cable, you need to select between output
on channel 3 or 4 usmg the Ch 314 sWitch next to the RF Out Jack on the back of
the SVR Recorder. To get the best picture, select the channel that IS not occupied
by a local broadcast channel. For example, If there IS a local broadcast statIOn on
channel 4, select channel 3. You will need to tune your VCR to thiS channel to
receive the SVR Recorder.
Your VCR should also have a sWitch that controls ItS channel output. Make sure
that both the SVR Recorder and any other eqUipment are all usmg the same
channel - that IS, if the SVR Recorder uses channel 3 for output, you must also
set your VCR to use channel 3 for output, and then tune your TV to channel 3 to
receive a signal.