Table of Contents
Advertisement
Troubleshooting
Symptom
Power cannot be turned on.
Camera is not automatically detected.
Unable to operate.
Images are not recorded.
Unable to play back audio sound.
Unable to operate in a section(s) in the viewer.
The message below appears after turning on
the power.
ACMOS Settings Wrong CMOS Date/ Time Not
Press F1 to Run SETUP Press F2 to load
default values and continueB
Actions when Warning Indicator Lights Up
Error Message
WARNING:HDD(Disk)
WARNING:HDD(Drive name:) Deleted
WARNING:HDD(Raid)
FAN STOP
Check to ensure that the power cable has been plugged in correctly.
Check to ensure that the power switch on the rear panel is switched on.
Follow instructions in the camera's [Instruction Manual] to check the IP
address settings.
When the IP Lease feature is in use, turn OFF the camera and ON again with
this unit started up.
If the user name and password of a camera have been changed from the
initial settings, there is a chance that the camera will not be automatically
detected.
Check to ensure that the operations are not locked. (A Page 114)
Check the [Camera Recording Settings].
Check to ensure that the scheduler is set to online.
Check the audio settings in camera properties under [Hardware Devices] in
[Advanced Configuration].
Check to ensure that [Listen to] is correctly selected in the [Audio] section.
If the network is congested, audio sounds may not be transmitted.
Check to ensure that the section you want to operate in is set to [Available]
under [Panels] in option settings. (A Page 174)
The built-in backup battery level is running low.
Consult your nearest JVC KENWOOD dealer.
The HDD seems to no longer be serviceable.
Consult your nearest JVC KENWOOD dealer.
Check to ensure that the power of the external HDD is switched on.
Check to ensure that the connecting cable is properly inserted.
If no abnormality is found above, consult your nearest JVC KENWOOD
dealer.
This is a HDD (during RAID setting) warning.
Consult your nearest JVC KENWOOD dealer.
Fan abnormality. Check to ensure that the fan is running.
If the fan is not moving, stop using it. Otherwise, it may break down.
Consult your nearest JVC KENWOOD dealer.
Action
Action to Take
193
Advertisement
Table of Contents
