802.11
MODE
To enable access control, select the Enable Access List check
2.
box.
Select either:
3.
Accept all devices listed below – allows only the listed
•
devices to access the wireless network.
Warning:
not in the list. Only devices in the list will be able to connect to
the wireless network.
Deny all devices listed below – denies access to the listed
•
devices. All other wireless devices will be able to access
the wireless network if they use the correct wireless
password.
Enter the MAC address of a device, then click Add.
4.
Repeat step 2 to add additional devices, as needed.
5.
To remove a specific device's MAC address, click the Remove
6.
button next to the specific MAC address.
When all changes are complete, click Apply to save changes.
7.
3.5/
802.11 MODE
From the 802.11 Mode page, you can limit the wireless access to your
network by selecting the 2.4 GHz and 5 GHz wireless communication
standard (mode) best suited or compatible with the devices you allow
access to your wireless network.
This will block wireless network access for all devices