Connect Your Gateway - Verizon FiOS-G1100 Quantum User Manual

2.0/
SETTING UP YOUR GATEWAY
There are three basic steps to setting up your Gateway:
Connect your Gateway to the Internet
Step 1:
Connect your network device to your Gateway
Step 2:
Configure your Gateway
Step 3:
Before you begin, if you are replacing an existing Gateway, disconnect
it. Remove all old Gateway components, including the power supply.
They will not work with your new Gateway.
STEP 1 - CONNECT YOUR GATEWAY
2.0a/
Remove your Gateway, Ethernet cables, and power adapter
1.
from the box.
Locate your high-speed Internet (WAN) outlet. This would be
2.
the wall jack installed previously by Verizon. Note the type of
jack may be either Ethernet or coaxial.
Connect your Gateway to the Internet (WAN).
3.
• If connecting the WAN using Ethernet,
use the supplied white Ethernet cable
and plug one end into the white Ethernet
WAN port on the back of your Gateway.
Plug the other end of the cable into the
high-speed Ethernet wall jack.
verizon.com/fios |
02 / CONNECTING
YOUR GATEWAY
©
2014 Verizon. All Rights Reserved.
18