Order Of Programming; Example Of Programming A Station Port - Samsung DCS Programming Manual

DCS
COMBINED PROGRAMMING MANUAL

Order of Programming

Carry out programming as shown in the diagram, below.
MMC 424
S0 Mapping (NOTE 1)
MMC 419
BRI-STN (NOTE 2)
Note:
1. This item does not have to be programmed prior to MMC 419 or MMC 418 (because those MMCs
have no effect on this item). However, this item must be preceded by MMC 423.
2. This item displays its name as "BRI-TRK" or "BRI-STN" according to the port setting in MMC 423.
3. This item is only applicable when a BRI access is programmed as P-MP MSN in MMC 419.
4. Only for a STATION port set in MMC 423.

Example of programming a STATION port

Assume that you have a BRI card installed in DCS and its ports are numbered from 701 to
708. You want to use the 4th BRI access (707 and 708) as a STATION port to connect ISDN
terminals. The procedure is:
MMC 423
S/T mode
S
MMC 418
Card Restart
Program MSN in your
ISDN terminal (NOTE 4)
3–19
SPECIAL APPLICATIONS
T
MMC 419
BRI-TRK (NOTE 2)
MMC 421
MSN Digit (NOTE 3)
NOVEMBER 2001