Mmc: 723 System Key Programming - Samsung DCS Programming Manual

DCS
COMBINED PROGRAMMING MANUAL
MMC: 723
3 3
DCS
This MMC is similar to MMC 722, Station Key Programming. The difference is that MMC 723 pro-
grams keys for all stations rather than individual stations.
All systems are provided with default functions for some keys to provide basic operation. For
example, keys 1 and 2 are set as CALL keys by default because it is recommended that these
keys should always function as CALL keys (but see Note, below). Other keys can be
programmed as described here. You can use the UP and DOWN keys to scroll through the
selectable functions when programming keys (see table at the end of this MMC).
Functions can also be entered via the dial keypad. For example, to assign the OHVA function,
key number 6 can be pressed three times. If the BOSS function is required, press 2 twice for the
first letter B, and then use the UP or DOWN key to change the selection from BARGE to BOSS.
Note: Default key functions are different for 408/408i systems compared to all other systems. For example,
keys 1 and 2 are not set as CALL keys by default as these are not required.
Programming in MMC 723 is also done on the basis of keyset type (12-button, 24-button, etc).
TYPE OF SET
Dial DCS/CII/816
0 24-BTN
1 12-BTN
2 6-BTN
3 –
4 48-BTN AOMS
5 –
6 28-BTN
7 18-BTN
8 8-BTN
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPEAKER
HOLD
ACTION
1. Open programming and select 723
Display shows
OR
For 408/408i systems, display shows
(but programming procedure is the same as follows)
SYSTEM KEY PROGRAMMING
3 3 3 3
CI CII
408/408i
24-BTN
24-BTN EURO
12-BTN
6-BTN
28-BTN
18-BTN
8-BTN
24B SIMPLE
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
MMC 723 (Page 1 of 3)
3 3 3 3
816 408i
DISPLAY
TYPE:24 BTN SETS
01:CALL1
OR
TYPE:24 BTN SETS
01:DT71
MMC PROGRAMS
NOVEMBER 2001
3 3
408