Part 3. System Administrator Programming; Open Customer Programming; Set Date And Time Display - Samsung DCS-816 System Administration And Special Features Manual

PART 3.
PROGRAMMING

3.1 OPEN CUSTOMER PROGRAMMING

Before any system programs can be accessed, you must first open Customer-level pro-
gramming using the passcode you have been assigned. This must be done using an LCD
keyset. Should it become necessary to change this passcode, see MMC 201.
• While your handset is on-hook, press TRSF and then dial 200.
• The display shows [ENABLE CUS. PROG. PASSCODE].
• Dial the four-digit passcode.
• The display shows [ENABLE CUS. PROG. - DISABLE].
• Dial 1 to enable (or press the Up or Down key to select)
• The display shows [ENABLE CUS. PROG - ENABLE].
To begin programming:
• Press the SPEAKER key and the three-digit program code you want to access.
Follow the instructions for that program.
NOTE: You must begin programming within 30 seconds. Once you start programming, any delay
of more than 30 seconds between keystrokes will cause the system to automatically close pro-
gramming. (The system timer can, however, be changed to allow more or less time before pro-
gramming mode is closed. Ask your dealer or the system installer for advice.)

3.2 SET DATE AND TIME DISPLAY

Should it ever become necessary to correct the date and time displayed on all of the key-
sets, do so as soon as you notice that they are incorrect. Automatic Night Service will not
work correctly and SMDRs will be of no value if the date and time are not correct.
The display format is as follows:
W Day of the week, 0-6
MM Month, 01-12
DD Day of the month
YY Year
HH Hours
MM Minutes
Failure to enter the time using the 24-hour clock will cause the date to change at 12:00
P.M. Open customer programming and follow the instructions below.
Open customer programming and follow the instructions below.
SYSTEM ADMINISTRATOR
[MMC 505]
enter 0 for Sunday and 6 for Saturday
enter 01 for January and 12 for December
enter a number in the range 01-31.
enter the last two digits of the year, e.g. 98.
use the 24-hour clock and enter a number in the
range 00-24.
enter a number in the range 00-59.
3 - 1
[MMC 200]