Mmc: 800 Enable Technician Program - Samsung DCS Programming Manual

DCS
COMBINED PROGRAMMING MANUAL
MMC: 800
3 3
DCS
Used to open and close system-level (technician) programming. If programming is not opened
and an attempt is made to access a system MMC, the error message "ACCESS DENIED" will be
displayed.
A four-digit passcode is required to access this MMC (which can be changed in MMC 801).
When opened, this MMC enables access to all MMCs.
The procedure below describes how to open programming.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPEAKER
ACTION
1. Press TRSF 800
Display shows
2. Enter passcode
DCS only – Correct code shows
OR
Compact II, 816 and 408/408i – Correct code
shows
Incorrect code shows (you return to the passcode
entry display so you can try again)
3. Enter 1 to enable or enter 0 to disable
OR
Press UP or DOWN to select
DCS only - Press RIGHT soft key to move to tenant
number and enter tenant number (1–2)
ENABLE TECHNICIAN
PROGRAM
3 3 3 3
CI CII
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
MMC 800 (Page 1 of 2)
3 3 408i 3 3
816
DISPLAY
ENABLE TECH.PROG
PASSCODE:
ENABLE TECH.PROG
PASSCODE:
ENABLE TECH.PROG
DISABLE TENANT:1
OR
ENABLE TECH.PROG
DISABLE
ENABLE TECH. PROG
PASSCODE ERROR
ENABLE TECH.PROG
ENABLE
OR
ENABLE TECH.PROG
ENABLE
ENABLE TECH.PROG
ENABLE
MMC PROGRAMS
NOVEMBER 2001
3 3
408
TENANT:1
TENANT: 2