Clip (Calling Line Identification Presentation) - Samsung DCS Programming Manual

DCS
COMBINED PROGRAMMING MANUAL
(Calling Line Identification Presentation)
Hardware Provisions
ISDN trunk cards.
Software Provisions
The MMCs related to CLIP are listed below with a short description of their uses. They are listed
in the recommended order in which they should be programmed. This sequence is suggested
so that the installer/technician gets a better understanding of how the feature works. There is no
technical reason to strictly follow this sequence.
MMC 312
l
(ALLOW CLIP)
MMCs 722 and 723
l
(STATION & SYSTEM KEY
PROGRAMMING)
MMC 728
l
(CLIP TRANSLATION TABLE)
MMC 725
l
(SMDR OPTIONS)
MMC 119
l
(SET CLIP DISPLAY)
MMC 501
l
(SYSTEM-WIDE TIMERS)
MMC 415
l
(REPORT TRUNK ABANDON
DATA)
MMC 608
l
(ASSIGN CLIP REVIEW BLOCK)
MMC 701
l
(ASSIGN COS CONTENTS)
MMC 724
l
(DIAL NUMBERING PLAN)
CLIP
Used to determine which keysets are allowed to r e-
ceive CLIP displays.
It is strongly recommended that all keysets allowed
CLIP in MMC 312 are programmed with a CLIP key
using this MMC.
Allows for the creation of a list of names that corre-
spond to numbers received from the Central Office
(C.O.). These names will be displayed when a call
rings in that has NUMBER ONLY data provided by the
C.O.
Provides the ability to print CLIP data and abandoned
calls on the Station Message Detail Recording
(SMDR) report.
Station users can determine what CLIP data is dis-
played when a call rings at the user's station.
You may need to adjust the CLIP DISPLAY timer. This
is the length of time that CLIP data is displayed at us-
ers' stations after the CLIP key is pressed.
Used to determine which trunks will record data in the
Call Abandon list and print with an Abandon "A" flag
on the SMDR report.
Used to assign CLIP Review blocks to keysets to al-
low the user to review CLIP data for previous calls
All CLIP features are included in this MMC so that the
system installer can allow or deny them.
CLIP features are included in this MMC to allow the
system installer to assign an access code where nec-
essary.
3–5
SPECIAL APPLICATIONS
NOVEMBER 2001
.