Locking The Cutting-Unit Pivot; Adjusting The Turf-Compensation Spring - Toro Reelmaster 7000-D Operator's Manual

Shutting Off the Engine (continued)
Lowering the cutting units relieves the hydraulic load from the system, prevents wear
on system parts, and prevents accidental lowering of the cutting units.
6. If the machine was run at full-load operation, allow the engine to idle for 5 minutes.
Idling the engine for 5 minutes allows the turbocharger to cool down before shutting
off the engine. Failure to do so may lead to turbocharger damage.
7. Rotate the key to O
8. Wait for all moving parts to stop.

Locking the Cutting-Unit Pivot

Cutting Grass on a Hill Side
Lock the cutting-unit pivots to prevent the cutting units from rotating downhill when cutting
across the face of a hill.
1. Secure the carrier frame
to the pivot yoke
2. Repeat step

Adjusting the Turf-Compensation Spring

The turf-compensation spring transfers the weight from the front roller to the rear roller. This
helps to reduce a wave pattern in the turf, also known as marcelling or bobbing.
Make spring adjustments with the cutting unit mounted to the traction unit, pointing
straight ahead and lowered to the ground.
3466-702A
and remove the key.
FF
of the cutting unit
with the snapper pin
1 at the other cutting units.
Page 5–13
IMPORTANT
IMPORTANT
.
G423878
IMPORTANT
Operation: During Operation