Checking The Interlock Switches - Toro Reelmaster 7000-D Operator's Manual

Fuel (continued)
Biodiesel (continued)
Blended fuel must meet:
Adding Fuel
1. Park the machine on a level surface, lower the
cutting units, shut off the engine, and remove
the key.
2. Clean the area around the fuel-tank cap
and remove the cap.
3. Fill the tank until the level is to the bottom of
the filler neck
4. Install the fuel-tank cap tightly.
Note:
use. Filling the fuel tank minimizes
condensation inside the tank.

Checking the Interlock Switches

If safety interlock switches are disconnected or damaged, the machine could operate
unexpectedly, resulting in minor or moderate injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches daily and replace any damaged
switches before operating the machine.
If your machine fails any of the interlock switch checks, contact your authorized Toro
distributor.
3466-702A
with the specified fuel.
If possible, fill the fuel tank after each
ASTM D975
EN 590
JIS K2204
CAUTION
IMPORTANT
Page 5–3
USA
European Union
Japan
G423841
Operation: Before Operation