Toro Reelmaster 7000-D Operator's Manual page 25

Positioning the Turf Compensating Spring and Installing
the Hose Guide (continued)
1. If the hairpin
the compensation-spring rod, remove the
hairpin and insert it in the hole next to the
bracket.
2. Remove the 2 flange locknuts (3/8 inch)
and 2 carriage bolts (3/8 x 1-1/4 inches)
that secure the turf-compensator bracket
the cutting-unit frame.
3. Remove the flange locknut (3/8 inch)
securing the bolt
carrier frame, and remove the compensation
spring from the cutting unit.
Note:
from the bolt.
3466-702A
is installed in the rear hole of
to the right tab
Do not remove the flange serrated nut
G410292
to
G402719
of the
G410295
Page 3–3 Setup: Installing the Cutting Units