Driving The Machine In Transport Mode - Toro Reelmaster 7000-D Operator's Manual

Cutting Grass with the Machine (continued)
4. Set the engine-speed switch to
5. Press the PTO switch to the E
6. Begin driving the machine into the cutting area and move the lower mow/raise control
lever forward.
Note:
lower before the rear cutting units
Note:
7. When you complete the mowing pass, move the lever for the mow-speed limiter
backward to lift the cutting units.
8. Perform a tear-shaped turn to quickly line up for your next pass.

Driving the Machine in Transport Mode

1. Press the PTO switch
position.
2. Move the lower mow/raise control lever
backward to raise the cutting units (transport
position).
3. Move the lever for the mow-speed limiter
backward to the T
4. Press the traction pedal to drive the machine.
3466-702A
The cutting units start running as they lower. The front cutting units are timed to
Cutting grass at a rate that loads the engine promotes DPF regeneration.
to the D
position.
RANSPORT
.
HIGH IDLE
position.
NGAGE
ISENGAGE
G423892
G423893
Page 5–15 Operation: During Operation