Toro Reelmaster 7000-D Operator's Manual page 135

Backlapping the Cutting Units (continued)
3. Rotate the lever for the mow-speed limiter
forward to the M
4. Press the PTO switch
position.
5. Move the lower mow/raise control lever
forward.
Note:
backward.
6. Apply lapping compound to the reels with a
long-handled brush.
Contacting the cutting units when they are moving will result in death or serious
injury.
• Do not use a short-handled brush.
• To avoid personal injury, ensure that you are clear of the cutting units before
proceeding.
7. If the reels stall or become erratic while backlapping, increase the throttle speed until the
reel stabilizes.
8. If you need to make an adjustment to the cutting units while backlapping, perform the
following steps:
A. Move the lower mow/raise control lever rearward.
Note:
B. Press the PTO switch to the D
C. Shut off the engine and remove the key.
D. Adjust the cutting units.
E. Repeat steps
9. Repeat step
Finishing Backlapping
If you do not return the backlap switch to the O
cutting units will not raise or function properly.
1. Shut off the engine and remove the key.
3466-702A
position.
OW
to the E
The reels you set for backlapping run
The cutting units shut off, but do not raise.
2 through 7.
6 for all cutting units that you want to backlap.
NGAGE
G425460
DANGER
position.
ISENGAGE
IMPORTANT
position after backlapping, the
FF
Page 6–51 Maintenance: Cutting Unit Maintenance