Inspecting The Rear Axle; Checking The Oil Level Of The Rear Axle; Changing The Oil In The Rear Axle - Toro Reelmaster 7000-D Operator's Manual

Changing the Planetary-Gear-Drive Oil (continued)
2. Install the fill plug
3. Wipe clean the planetary and brake housings.
4. Drain and fill the planetary-gear-drive on the
other side of the machine.

Inspecting the Rear Axle

Visually inspect the rear axle for leaks. Make all necessary repairs before operating.

Checking the Oil Level of the Rear Axle

Axle Oil Specification: SAE 85W-140 gear oil
1. Prepare the machine for maintenance.
2. Remove a check plug
axle housing.
3. Check the gear oil level in the axle through the
check-plug hole.
Note:
level is at the bottom of the check-plug hole.
4. If the gear-oil level low, remove the fill plug
and add the specified gear oil to raise the oil
level to the bottom of the check-plug hole.
5. Install the check plug.
6. If removed, install the fill plug.

Changing the Oil in the Rear Axle

Rear Axle Oil Capacity: 2.4 L (80 fl oz)
3466-702A
and the check plug.
from the end of the
The gear-oil level is correct if the oil
G425215
G425336
Page 6–31 Maintenance: Drive System Maintenance