Cleaning The Fuel-Intake Screen; Servicing The Diesel-Oxidation Catalyst (Doc) And The Soot Filter - Toro Reelmaster 7000-D Operator's Manual

Cleaning the Fuel-Intake Screen

The fuel-intake tube, located inside the fuel tank, is equipped with a screen to help prevent
debris from entering the fuel system. Remove the fuel-intake tube and clean the screen as
required.
1. Prepare the machine for maintenance.
2. Tilt the seat.
3. Remove the clamp
to the fuel pick-up tube.
4. Remove the fuel pick-up tube and rubber
bushing
5. Clean the screen
up tube.
6. Insert the fuel pick-up tube and rubber bushing
into the tank until the bushing is seated into the
tank.
7. Assemble the hose onto the fuel pick-up tube
and secure it with the clamp.
8. Lower and latch the seat.
Servicing the Diesel-Oxidation Catalyst (DOC) and the
Soot Filter
If engine faults
ENGINE SPN
16 show on the InfoCenter, clean the soot filter as
follows:
1. Refer to the Engine section in the Service Manual for information on disassembling and
assembling the diesel-oxidation catalyst and the soot filter of the DPF.
2. Contact to your authorized Toro distributor for diesel-oxidation catalyst and the soot filter
replacement parts or service.
3. Contact your authorized Toro distributor to reset the engine ECU after installing a clean
DPF.
3466-702A
that secures the hose
from the tank.
at the end of the fuel pick-
CHECK ENGINE SPN
3720 0, or
FMI CHECK ENGINE SPN
3251 0,
FMI CHECK
3720
FMI
Page 6–23
G425144
G411644
G415047
G411642
Maintenance: Fuel System Maintenance