Adjusting the Cutting-Unit Counterbalance (continued)
Lift arm (rear—cutting unit #2 or #3)
Torsion spring
Locknut
Lift-arm plate
3. While holding the spring, remove the bolt, washer, and locknut from the lift plate.
4. Align the spring leg above the desired hole location.
5. Install the bolt, washer, spacer, and locknut at the hole location.
6. Slowly lower the spring leg onto the spacer.
7. Repeat steps
3466-702A
2
through
6
at the rear cutting-unit-lift arm.
Page 5–17
G424029
Spacer
Washer
Bolt
Operation: During Operation