Cutting Grass With The Machine - Toro Reelmaster 7000-D Operator's Manual

Adjusting the Turf-Compensation Spring (continued)
1. Make sure that the hairpin
rear hole in the spring rod
Note:
the hairpin to the spring-rod hole next to the
turf-compensation spring
2. Tighten the hex nuts
spring rod until the compressed length of the
spring is 15.9 cm (6.25 inches).
Note:
decrease the spring length by 13 mm (1/2
inch). Ground following will be slightly decreased.
Note:
Aggressiveness of Cut setting is changed.

Cutting Grass with the Machine

1. Drive the machine to the mowing area and align the machine outside the cutting area for
the first cutting pass.
2. Ensure that the PTO switch is set to the D
Engine-speed switch
3. Use your foot to move the lever for the mow-speed limiter forward, to the M
Mow-speed limiter
Operation: During Operation
When servicing the cutting unit, move
on the front end of the
When operating on rough terrain
The turf compensation setting will need to be reset if the HOC setting or the
is installed in the
.
.
ISENGAGE
G423889
PTO switch
G423890
Page 5–14
G402845
position.
Mow/raise control lever
position.
OW
3466-702 A