Before Operations Checks; Checking The Interlock System; During Operation; General Safety - Toro Sand Pro 3040 Operator's Manual

Traction unit
Hide thumbs Also See for Sand Pro 3040:
Table of Contents

Advertisement

system could be damaged. Do not mix oil
with gasoline.

Before Operations Checks

Perform the following daily procedures before
operating the machine:
Checking the Interlock System (page 16)
Checking the Engine-Oil Level (page 24)
Checking the Tire Pressure (page 29)
Checking the Hydraulic Lines and Hoses (page
33)
Checking the Hydraulic-Fluid Level (page 33)
Checking the Interlock
System
CAUTION
If safety interlock switches are disconnected
or damaged the machine could operate
unexpectedly and cause personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
The purpose of the interlock system is to prevent the
engine from cranking or starting unless the traction
pedal is in the
NEUTRAL
should shut off if the traction pedal is moved either
forward or reverse without an operator in the seat.
1.
Position the machine in a wide-open area free of
debris and bystanders. Shut off the engine.
2.
Sit on the seat and engage the parking brake.
3.
Press the traction pedal in forward and reverse
while trying to start the engine.
Note:
If the engine cranks, there may be a
malfunction in the interlock system. Repair it
immediately.
If the engine does not crank, the system is
operating correctly.
4.
Stay seated on the seat, with the traction pedal
in the
position and the parking brake
NEUTRAL
engaged, and start the engine.
5.
Rise off the seat and slowly press the traction
pedal.
Note:
The engine should shut off in 1 to 3
seconds. Correct the problem if the system
does not operate properly.
position. Also, the engine

During Operation

Note:
Determine the left and right sides of the
machine from the normal operating position.

General Safety

The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
Wear appropriate clothing, including eye
protection; slip-resistant, substantial foot
protection; long pants; and hearing protection. Tie
back long hair and do not wear loose jewelry.
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
Never carry passengers on the machine and keep
bystanders and pets away from the machine
during operation.
Operate the machine only in good visibility to avoid
holes or hidden hazards.
Avoid operating on wet grass. Reduced traction
could cause the machine to slide.
Before you start the engine, ensure that all drives
are in neutral, the parking brake is engaged, and
you are in the operating position.
Look behind and down before backing up to be
sure of a clear path.
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
Do not operate near drop-offs, ditches, or
embankments. The machine could suddenly roll
over if a wheel goes over the edge or if the edge
gives way.
Stop the machine and inspect the attachment
after striking an object or if there is an abnormal
vibration in the machine. Make all necessary
repairs before resuming operation.
Slow down and use caution when making turns
and crossing roads and sidewalks with the
machine. Always yield the right-of-way.
Never run an engine in an area where exhaust
gasses are enclosed.
Never leave a running machine unattended.
Before leaving the operating position, do the
following:
– Park the machine a level surface.
– Lower the attachments.
– Engage the parking brake.
– Shut off the engine and remove the key.
16

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sand pro 5040

Table of Contents