Replacing An Elight Actuator - Huawei V500R003C00 Maintenance Manual

FusionModule2000 Smart Modular Data Center
Maintenance Guide
Figure 6-64 Removing a strip light
(1) Strip light extension cable
Step 7 Install a new strip light.
Step 8 Install the new strip light by performing the preceding steps in reverse order.
Step 9 On the ECC800-Pro WebUI, choose Maintenance > Opening Guide > Linkage Test >
eLight actuators Commissioning and click Test. The eLight strip light is lit up in red, green,
blue, and white in sequence for 3 seconds respectively, and then turns off.
----End

6.4.20 Replacing an eLight Actuator

Impact on the System
The eLight strip light is off during replacement.
Preparations


Issue 05 (2020-03-25)
Tools: ESD gloves, Phillips screwdriver, step ladder, label, marker
Material: eLight actuator
Copyright © Huawei Technologies Co., Ltd.
(2) Strip light extension cable
6 Parts Replacement
107