Servicing The Engine Oil And Filter - Toro Reelmaster 5610 Operator's Manual

1. Park the machine on a level surface, shut off the
engine, set the parking brake, and remove the
key from the ignition switch.
2. Open the hood.
3. Remove the dipstick, wipe it clean, and install
it (Figure 76).
Figure 76
1. Dipstick
4. Remove the dipstick and check the oil level on
the dipstick.
Note:
The oil level should be up to the Full
mark.
5. If the oil level is below the Full mark, remove the
fill cap (Figure 77), and add oil until the level
reaches the Full mark on dipstick.
1. Oil-fill cap
Important:
the engine-oil level between the upper and
lower limits on the oil gauge. Engine failure
g003950
may occur as a result of over filling or under
filling the engine oil.
6. Install the oil-fill cap and close the hood.
Servicing the Engine Oil
and Filter
Change the engine oil and filter initially after the first
50 hours of operation and every 150 hours thereafter.
1. Remove the drain plug
oil flow into a drain pan.
1. Oil drain plug
2. When the oil stops, install the drain plug.
45
Figure 77
Do not overfill. Be sure to keep
(Figure 78) and let the
Figure 78
g004134
g003970