Table of Contents
Advertisement
Figure 10
1. Main-power connectors
8
Adjusting the Machine
Settings
No Parts Required
Procedure
Use the InfoCenter to adjust the machine settings;
refer to
InfoCenter (page
2. Connector cover
19).
9
Adding Rear Weight
Parts needed for this procedure:
Rear Weight Kit (order separately; contact your
1
authorized Toro distributor)
Procedure
This machine complies with applicable standards with
the Rear Weight Kit installed. Refer to your authorized
Toro distributor for the Rear Weight Kit.
If the machine comes with a 3-Wheel Drive kit, you do
not need to install the Rear Weight Kit.
10
g389174
Installing the CE/UKCA
Decals
If Required (CE/UKCA-Compliant
Countries Only)
Parts needed for this procedure:
1
Production year decal
1
CE warning decal (Part Number 139-8321)
1
CE/UKCA decal (Part Number 138-9470)
Procedure
If you use this machine in a country that complies to
CE/UKCA standards, install the following decals and
hood latch:
•
Production year decal and CE/UKCA decal:
apply the decals on the frame tube below the seat
and serial plate; refer to
15
Figure
11.
Advertisement
Table of Contents
