Philips LPC213 Series User Manual page 143

Philips Semiconductors
Volume 1
11.9.19 State : 0x50
Data has been received, ACK has been returned. Data will be read from I2DAT. Additional
data will be received. If this is the last data byte then NOT ACK will be returned, otherwise
ACK will be returned.
11.9.20 State : 0x58
Data has been received, NOT ACK has been returned. Data will be read from I2DAT. A
Stop condition will be transmitted.
11.9.21 Slave Receiver States
11.9.22 State : 0x60
Own Slave Address + Write has been received, ACK has been returned. Data will be
received and ACK returned.
11.9.23 State : 0x68
Arbitration has been lost in Slave Address and R/W bit as bus Master. Own Slave Address
+ Write has been received, ACK has been returned. Data will be received and ACK will be
returned. STA is set to restart Master mode after the bus is free again.
User manual
1. Read data byte from I2DAT into Master Receive buffer.
2. Decrement the Master data counter, skip to step 5 if not the last data byte.
3. Write 0x0C to I2CONCLR to clear the SI flag and the AA bit.
4. Exit
5. Write 0x04 to I2CONSET to set the AA bit.
6. Write 0x08 to I2CONCLR to clear the SI flag.
7. Increment Master Receive buffer pointer
8. Exit
1. Read data byte from I2DAT into Master Receive buffer.
2. Write 0x14 to I2CONSET to set the STO and AA bits.
3. Write 0x08 to I2CONCLR to clear the SI flag.
4. Exit
1. Write 0x04 to I2CONSET to set the AA bit.
2. Write 0x08 to I2CONCLR to clear the SI flag.
3. Set up Slave Receive mode data buffer.
4. Initialize Slave data counter.
5. Exit
1. Write 0x24 to I2CONSET to set the STA and AA bits.
2. Write 0x08 to I2CONCLR to clear the SI flag.
3. Set up Slave Receive mode data buffer.
4. Initialize Slave data counter.
Rev. 01 — 24 June 2005
UM10120
2
Chapter 11: I C interfaces
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
143