NorthStar 972 Quickstart Manual And Reference Manual page 85

Reference Manual Revision B
NOTE:
If you press any function key on the control
unit during the transfer, the message
"Transfer aborted by key hit"
displayed, and the process will be aborted.
The control unit will then display the
requested function. You can press any key
on the second unit, however, without
interrupting the transfer process.
To intentionally stop the transfer at any time,
Stop
press the key. The control unit will
Transfer aborted by
display the message "
key hit
." Waypoints and routes transferred
up to that point are in the receiving unit (be
aware that routes may not contain all of their
waypoints due to the transfer interruption).
Start
Press the key again to restart the
entire transfer process from the beginning.
1. Choose the unit you'd like to use as the
control unit. The instructions below are for a
972.
Remember: You can use either of the two
units because both units are capable of
importing or exporting waypoints and
routes. Make sure the second unit is on.
2. At the control unit, press WAYPTS/ROUTES.
3. Press
will be
Waypoints and routes screen
4. Decide whether you want to import waypoints
into the control unit, or export them to the sec-
ond unit.
Reference section 5 — Creating waypoints and routes
Transferring waypoints/routes to other units
Import/Export
.
Import/Export screen
81